Pages

Power Factor and Efficiency of Induction Motors



Power factor


Induction motors present a lagging (inductive) power factor to the power line. The power factor in large fully loaded high speed motors can be as favorable as 90% for large high speed motors. At ¾ fullload, the largest high speed motor power factor can be 92%. The power factor for small low-speed motors can be as low as 50%. At starting, the power factor can be in the range of 10% to 25%, rising as the rotor achieves speed.

Power factor (PF) varies considerably with the motor mechanical load (Picture 1). An unloaded motor is analogous to a transformer with no resistive load on the secondary. Little resistance is reflected from the secondary (rotor) to the primary (stator). Thus the power line sees a reactive load as low as 10% PF. As the rotor is loaded an increasing resistive component is reflected from rotor to stator, increasing the power factor.



Picture 1: Induction motor power factor and efficiency


Efficiency


Large 3-phase motors are more efficient than smaller 3-phase motors and most all single phase motors. Large induction motor efficiency can be as high as 95% at full load, though 90% is more common. Efficiency for a lightly load or no-loaded induction motor is poor because most of the current is involved with maintaining magnetizing flux. As the torque load is increased, more current is consumed in generating torque while current associated with magnetizing remains fixed. Efficiency at 75% FLT can be slightly higher than that at 100% FLT. Efficiency is decreased a few percent at 50% FLT and decreased a few more percent at 25% FLT. Efficiency only becomes poor below 25% FLT. The variation of efficiency with loading is shown on Picture 1 above.

Induction motors are typically oversized to guarantee that their mechanical load can be started and driven under all operating conditions. If a poly-phase motor is loaded at less than 75% of rated torque where efficiency peaks, efficiency suffers only slightly down to 25% FLT.


Nola power factor corrector


Frank Nola of NASA proposed a power factor corrector (PFC) as an energy saving device for single phase induction motors in the late 1970's. It is based on the premise that a less than fully-loaded induction motor is less efficient and has a lower power factor than a fully loaded motor. Thus, there is energy to be saved in partially loaded motors (1-φ motors in particular).

The energy consumed in maintaining the stator magnetic field is relatively fixed with respect to load changes. While there is nothing to be saved in a full- loaded motor, the voltage to a partially-loaded motor may be reduced to decrease the energy required to maintain the magnetic field. This will increase power factor and efficiency. This was a good concept for the notoriously inefficient single-phase motors for which it was intended.

This concept is not very applicable to large 3-phase motors. Because of their high efficiency (90+%), there is not much energy to be saved. Moreover, a 95% efficient motor is still 94% efficient at 50% full-load torque (FLT) and 90% efficient at 25% FLT. The potential energy savings in going from 100% FLT to 25% FLT is the difference in efficiency 95% - 90% = 5%. This is not 5% of the full load wattage but 5% of the wattage at the reduced load. The Nola power factor corrector might be applicable to a 3-phase motor which idles most of the time (below 25% FLT) - like a punch press. The payback period for the expensive electronic controller has been estimated to be unattractive for most applications, although it might be economical as part of an electronic motor starter or speed control.

1 comment:

  1. Calculate the full load efficiency of a three phase induction motor given:

    Rating = 12 Kw Show all calculations
    Voltage = 415 Volts
    P.f. = 0.75
    IF.L.C. = 25 Amperes

    ReplyDelete