Pages

Anti-logarithmic Amplifier


The anti-logarithmic amplifier circuit configuration is shown on the Picture 1. As we can see from the picture, this circuit is basically the inverting amplifier with the difference that the resistor R1 is replaced with the diode D. Here, the input current is equal to the the diode's current. Since, for the current that flows through the diode D we can write:

id ~= Is*exp(Vd/Vt)

where the Vd is the diode's voltage and Vt is the thermal voltage, which in general is equal to 25 mV at room temperature. Or, we can write:

ii ~= Is*exp(Vi/Vt)

Thus, for the output voltage we can write:

Vo = -iiRf ~= Is*Rf*exp(Vi/Vt)

So, according to the last relation, we can state that the output voltage Vo is proportional to the exponent of the input voltage Vi. That's why this circuit configuration is called anti-logarithmic amplifier.



Picture 1: Anti-logarithmic Amplifier


The wave forms of the input and output voltages are shown on the Picture 2. The input voltage Vi is represented with the blue line plot on the graph and the output voltage Vo is represented with the green line plot. The input voltage signal is with sinusoidal waveform with amplitude of 1 V and at frequency of 500 Hz. The output voltage signal is about -11 V for the positive half period of the input voltage signal and about 4.6 nV or approximately 0 V for the negative half period of the the input voltage signal.


Picture 2: The input and output voltage wave forms of the anti-logarithmic amplifier

No comments:

Post a Comment